<p>is better? & Nbsp; MDF & nbsp; MDF "MDF is MDF, it is based on wood fiber or other plant fiber As a raw material, broken, fiber separation, drying urea urea after application or other suitable adhesive, and then made by hot pressing a man-made sheet. Advantages: material is relatively small, cut the edge of the edge will be sealed well, and will not be easy to open plastic. Easy to crush into a variety of shapes, easy to do modeling, so usually do more door </p>
<p>or backplane. Disadvantages: because the substrate is the powder as raw materials, the use of glue than the particle board, more likely to produce environmental problems. Secondly, due to the density of the adhesive plate, the internal structure of the space is less, less moisture resistance, soak a density of 24 hours in the water, more than ten hours later clearly see the density board four sides raised up, deformation. Second, the solid wood particle board solid wood </p>
<p>particle board, is made of wood or other lignocellulosic material scrap, after the application of adhesive in the heat and pressure under the action of synthetic wood-based panel. Principle and density board is the same. Advantages: (1) solid wood particles inside the cross-shaped structure of the particles. So the nail force is good, you can nail round nails, screws. These machinability is significantly better than MDF. (2) solid wood particle density is higher, the board </p>
<p><br />
<br />
</p>