<P>Plastic wood can be used ordinary woodworking machinery cutting, sawing, drilling, open tenon. With the expansion tube will be fixed on the floor of the plastic keel, expansion tube fixed point spacing 500mm-600mm, screw cap is less than the surface of the wood keel, wood keel need to do the whole flat.</p>
<P>Plastic wood and plastic wood can be used between the self-tapping screw fastening, outdoor recommended the use of stainless steel tapping screws; plastic wood and steel plate to use self-drilling tapping screws. Plastic wood and plastic wood between the use of self-tapping screws when the hole should be the first hole, that is, pre-drilling. The diameter of the pre-drilled hole should be less than 3/4 of the screw diameter. When installing the outdoor floor, use a screw between the plastic and the keel. Plastic wood flooring and keel junctions are plastic buckle will be plastic wood floor and keel connection fixed.</P>
<P>Fixed plastic wood keel will be plastic wood keel evenly arranged, spread in the formation of cement on the ground. It is recommended that the distance between each keel be 30 cm apart. With a drill in the keel on the hole, the aperture should be slightly smaller than the diameter of the stainless steel screws, then screw the screw has been drilled hole will be fixed to the cement floor. Construction nail head should be fully screwed into the keel, do not bare outside the keel, otherwise it may lead to uneven floor layout.</P>
<P>Fixed the first floor of each floor on the left and right sides were yin and yang trough. When paving the first floor, you can use the woodworking tool to cut off or wipe the outer part of the outer floor of the first floor, then drill the hole with an electric drill on the floor surface and screw the nail to fix it on the keel. Another way is to use our company with the edge of the edge of the first board to seize the first floor of the floor of the sun, and then on the use of electric drill hole, screw into the nail fixed. After installing the edge band,
the floor will look like a frame, so use the latter method will make the finished floor more beautiful effect, it is recommended to use. And then in the first floor of the floor on the inside of the slot on the drill hole screw into the screw to the fixed on the keel.</P>
