containing paint and insoluble grease or impurities
Posted: Fri Oct 27, 2017 1:13 am<p>crust, you can use a scraper to remove large pieces of patent leather, and filter solution and then use. 2, whitening paint the color of the film than the original white, was white mist. The reasons for the construction equipment is not clean, containing paint and insoluble grease or impurities, the paint may dry after the white; no use of supporting thinner, low boiling point solvents are more, or thinner contains too much moisture; construction environment humidity </p>
<p>Too much, the construction of oil paint when the moisture absorption, dry lead to paint white. Solution: construction equipment should ensure clean and clean; use of supporting thinner; use slow dry thinner, if necessary, add a small amount of anti-white water. 3, pinhole problems such as needle-like size of the hole. The reason for this situation may be painted, due to the high temperature of the environment, the solvent is too volatile, the film itself is too late to </p>
<p>make up the gap, and the formation of a series of small holes that pinhole; construction is not meticulous, putty layer or primer layer is not smooth ; Construction environment relative humidity is too high or spraying equipment, oil and water separator failure. Solution: the construction environment temperature should not be too high, if the temperature to accelerate curing, should be placed at room temperature for about 20 minutes, so that the solvent fully </p>
<p><a href='http://thedecking.co.uk/outdoor-bench/5432.html'>decking straight on ground in finland</a><br />
<a href="http://abcdeckco.com/fence/ultra-vinyl-fencing-redding-ca.html">ultra vinyl fencing redding ca</a><br />
<a href='http://technofloor.in/diy-floor/322.html'>free standing ground level deck</a></p>
<p>Too much, the construction of oil paint when the moisture absorption, dry lead to paint white. Solution: construction equipment should ensure clean and clean; use of supporting thinner; use slow dry thinner, if necessary, add a small amount of anti-white water. 3, pinhole problems such as needle-like size of the hole. The reason for this situation may be painted, due to the high temperature of the environment, the solvent is too volatile, the film itself is too late to </p>
<p>make up the gap, and the formation of a series of small holes that pinhole; construction is not meticulous, putty layer or primer layer is not smooth ; Construction environment relative humidity is too high or spraying equipment, oil and water separator failure. Solution: the construction environment temperature should not be too high, if the temperature to accelerate curing, should be placed at room temperature for about 20 minutes, so that the solvent fully </p>
<p><a href='http://thedecking.co.uk/outdoor-bench/5432.html'>decking straight on ground in finland</a><br />
<a href="http://abcdeckco.com/fence/ultra-vinyl-fencing-redding-ca.html">ultra vinyl fencing redding ca</a><br />
<a href='http://technofloor.in/diy-floor/322.html'>free standing ground level deck</a></p>