furniture, one of the basic means
Posted: Wed Aug 02, 2017 11:46 am<p>temperature should be balanced, not suddenly change, and well ventilated. Wet operation has been completed, and has a certain intensity, the environment is relatively dry. General paint project construction environment temperature should not be lower than 10 degrees, relative humidity should not be greater than 60%. 2, in the room higher than 3.6m work, should be built in advance scaffolding, and without </p>
<p>prejudice to the operation shall prevail. 3, large area construction should be done before the model room, after the relevant quality department inspection, identification of qualified, you can carry out a large area construction. 4, the operation should be carried out before the handover inspection work, and the remaining issues properly handled. 5, wood base moisture content generally should not be greater than </p>
<p>12%. Four. Operation process 1, process flow: base treatment, polishing oil powder, full scraping oil puttyVarnish commonly used wood finishes, furniture surface, is a transparent coating. Varnish finish in the construction engineering, there may be some problems, such as the base, processing finishes appear on the flow and light loss problems, if these problems arise, how should solve? Xiaobian for everyone </p>
<p><br />
<br />
</p>
<p>prejudice to the operation shall prevail. 3, large area construction should be done before the model room, after the relevant quality department inspection, identification of qualified, you can carry out a large area construction. 4, the operation should be carried out before the handover inspection work, and the remaining issues properly handled. 5, wood base moisture content generally should not be greater than </p>
<p>12%. Four. Operation process 1, process flow: base treatment, polishing oil powder, full scraping oil puttyVarnish commonly used wood finishes, furniture surface, is a transparent coating. Varnish finish in the construction engineering, there may be some problems, such as the base, processing finishes appear on the flow and light loss problems, if these problems arise, how should solve? Xiaobian for everyone </p>
<p><br />
<br />
</p>