<p>the point to determine the location of the nail hole on the wall, with the yuan to the connector fixed to the wall, in the fixed door frame And the wall gap into the wood, so that the door frame and the wall connected firmly dense. 6. When installing the door hinge, the upper and lower hinges first screw a screw, and then close the door to check whether the gap is suitable, check the door and doors are in the same plane, the door has no fall, after the other screws </p>
<p>will be tightened, Directly into the door frame, the installation of door frames and doors, to ensure that the file door is consistent with the wrong place, close the gap tight, solid, no damage to the decorative surface. 7. Determine the installation of the line after installation, the installation of the line with the width of the wall and the door frame may be, such as the wall than the case of narrow, available side of the line side of the wall, such as the case than the wall </p>
<p>narrow case On the contrary, the lines can be removed on both sides of the cap, the line with a nail fixed back cover can be. 8. After the installation of the door to pay attention to a comprehensive inspection, the door is flexible, whether the closure of compliance. Corner wall, T-wall hole should be selected than the door size of small 45MM to 65MM wide suite of doors, the installation of wood with another "false wall" false wall width 45MM to </p>
<p><br />
<br />
</p>
