1, in the milling production line, if the motor power is not enough, it will be easy to cause the motor due to the voltage is not enough to drive the normal operation of calcite ultrafine grinding, so as to extend the start-up time of the equipment, even caused by the calcite ultrafine grinding can not start the situation occurred.
2, calcite ultrafine grinding start-up speed in a large extent affected by the current, if we in the other side of the process of ultrafine grinding, the current instability is very easy to cause the contactor, circuit and motor burnout, which will bring a great impact on the equipment. If this is a long time, it will shorten the service life of calcite ultrafine grinding.
3, in order to prevent the calcite ultrafine grinding start up problems, we should pay attention to the correct starting sequence and methods. For example, before the other side of the stone superfine grinding start, to all the strict condition of the door to do a good check, and observe the equipment grinding cavity inside the residual material, and so on, the wind turbine and the host to make adjustments.
4, in order to ensure the normal nature of ultrafine calcite grinding, we also need to carefully check the exhaust valve of the equipment, to ensure that it is in full open state, and do a good job on each bolt screws fastening. Then, in the absence of any anomalies, in accordance with the start-up hoist-crusher-analysis machine-mainframe-feeder, such as the order to open the machine.
In short, if we can not start the calcite ultrafine grinding, will cause great damage to the equipment, not only affect the smooth and efficient milling operation, but also shorten the service life of the equipment.Statistics: Posted by grinding123 — Wed Oct 18, 2017 6:40 am
]]>